Skip to content
PermitBasis

Sherwood, AR · Pulaski County

Sherwood HVAC / Mechanical Replacement Permit Fees and Submittal Checklist

Replacement of heating, cooling or ventilation equipment. Usually a mechanical permit only, with no building permit.

01

Sherwood Fee Estimate

Fee Estimate

$

Permit valuation may differ from your construction budget when the city applies its own valuation method.

sq ft

Estimate · Sherwood, AR

Unavailable

Sherwood does not publish this fee schedule. Known fees below total $0.00. Call (501) 835-4753 for a quote.

  • Mechanical permit feeUnavailable

    Sherwood adopted its building fee schedule by reference (Ord. 1599) and does not publish it. Only the new-home rate is codified.

Need sealed MEP drawings, permit expediting, or 3 bids from ACLB-licensed contractors in Sherwood?

Sources and Assumptions

Schedule
Sherwood Code Title 11 (§ 11.04.07)
Source reviewed on
October 20, 2026
Assumes
Commercial occupancy; $50,000 valuation and 4,000 sq ft as entered.

PermitBasis is an independent planning resource. The issuing authority determines final fees and requirements.

02

Common Project Values

Estimated Sherwood fees for hvac / mechanical replacement projects at six standard sizes, computed with the same rules as the calculator. Trade permits excluded.

  • Single split system

    $12,000 · 1,800 sq ft

    Unavailable

  • Two-system home

    $25,000 · 3,000 sq ft

    Unavailable

  • Small RTU

    $50,000 · 4,000 sq ft

    Unavailable

  • Multiple RTUs

    $150,000 · 12,000 sq ft

    Unavailable

  • Chiller / VRF

    $400,000 · 30,000 sq ft

    Unavailable

  • Central plant

    $900,000 · 50,000 sq ft

    Unavailable

03

Central Arkansas Cost Comparison

The same project priced in all eight cities. Valuation-based cities (fee grows with project cost) and square-footage cities (fee grows with floor area) can differ widely for the same building. Full comparison →

04

Sherwood Submittal Checklist

Required and conditional documents for this project type. Confirm this requirement with the city.

Submittal Checklist0 of 5 ready
  1. Sherwood permit application

    Submit through Sherwood Engineering, Permits & Planning. Include the project address, parcel number, owner, contractor and declared valuation.

    Permit portal ↗
  2. Licensed HVACR contractor

    Mechanical permits are pulled by an HVACR contractor licensed by the Arkansas Department of Health HVACR Licensing Board, or by a homeowner for their own residence where the city allows it.

    ADH HVACR licensing ↗
  3. Equipment schedule

    Make, model, tonnage or BTU rating and efficiency for each unit being replaced or added.

  4. Structural letter for rooftop units

    Conditional

    When a new rooftop unit is heavier than the one it replaces or sits in a new location, a structural evaluation is usually required.

    Applies when: Rooftop equipment changes weight or location

  5. Electrical permit for new circuits

    Conditional

    A separate electrical permit is required when the replacement needs a new circuit, disconnect or panel work.

    Applies when: New circuit, disconnect or panel work

Permit office

Sherwood Engineering, Permits & Planning

Confirm hours and submittal format with the city before you go.

Inspection Roadmap

  1. 1

    Mechanical final

    After equipment is set, connected and operating

  2. 2

    Electrical final

    Conditional

    After new circuits or disconnects are complete

    Only with an electrical permit

05

Frequently Asked Questions

How much does a hvac / mechanical replacement permit cost in Sherwood, Arkansas?

Sherwood, AR does not publish the mechanical permit fee for a $50,000 (4,000 sq ft) hvac / mechanical replacement in a form PermitBasis can confirm, so no total is estimated. Call Sherwood Engineering, Permits & Planning at (501) 835-4753 for a quote.

Does Sherwood, AR calculate building permits by square footage or project valuation?

Sherwood prices new homes at $0.16 per square foot under roof. Fees for other building work come from a schedule the city adopted by reference but does not publish, so PermitBasis shows them as unavailable. Trade permits are billed per item (openings, fixtures, equipment).

How long does commercial plan review take in Sherwood, AR and what does it cost?

Sherwood does not publish a plan review fee. The city does not publish a plan review turnaround time; ask the permit desk for the current queue when you submit.

Do I need an Arkansas commercial contractor license to pull a permit in Sherwood?

Yes, for commercial work of $50,000 or more. Under A.C.A. § 17-25-101, any project other than a single-family residence costing $50,000 or more in labor and materials requires an Arkansas Contractors Licensing Board commercial license, and the building official must see proof of license before issuing the permit. Residential builders and remodelers need an ACLB residential license for jobs over $2,000. Splitting a contract to stay under a threshold is not allowed. Licensed electricians, plumbers and HVACR contractors pull their own trade permits in Sherwood.

06

Sources and Assumptions

Schedule
Sherwood Code Title 11 (§ 11.04.07)
Source reviewed on
October 20, 2026
Data status
Some components are confirmed; unconfirmed components are marked Unavailable instead of estimated.
  • Work without a permit is a misdemeanor with fines of $100–$500 per offense (§ 11.01.04); no fee multiplier is published.
  • Fees for work other than new homes come from the schedule attached to Ord. 1599 / Ord. 2057, which is not published online. Re-inspection is $25.

PermitBasis is an independent planning resource. The issuing authority determines final fees and requirements.